Step 7-Covering up the console holes with Black Starboard…
This was really sobering….I got the table saw, a fine blade, and another gallon of Acetone. I went and cut the starboard. The sizing was well done then I looked for screws to install it. I settled on some #8 and afterward I felt they were too large. I also forgot to use 5200 on the back and I could have beveled the piece (I need a router table). In a nutshell I wasn’t happy at all after all the work and expense I’ve put into it. Very mediocre. I did not continue and perhaps I will make another attempt tomorrow. This morning I went out and got #6-1” stainless steel screws for the top. I also need to cut a recess so the screws sit low.
This really bummed me out but I am confident I will take it apart and fix it all.
-This post will be updated in the future.
No comments:
Post a Comment